一.if语句
if语句条件中定义变量是属于局部变量，只有对应的if中的条件和执行语句中有效。
if x > 10 {
fmt.Println("x is greater than 10")
} else {
fmt.Println("x is less than 10")
}
// 计算获取值x,然后根据x返回的大小，判断是否大于10。
if x := computedValue(); x > 10 {
fmt.Println("x is greater than 10")
} else {
fmt.Println("x is less than 10")
}
//这个地方如果这样调用就编译出错了，因为x是条件里面的变量
fmt.Println(x)
if integer == 3 {
fmt.Println("The integer is equal to 3")
} else if integer < 3 {
fmt.Println("The integer is less than 3")
} else {
fmt.Println("The integer is greater than 3")
}
二.循环语句for
//无限循环 必须要break跳出
a:=1
for{
a++
if a >= 3 {
break
}
}
sum := 1
for sum < 1000 {
sum += sum
}
sum := 1
for ; sum < 1000; {
sum += sum
}
for index := 10; index>0; index-- {
if index == 5{
break // 或者continue
}
fmt.Println(index)
}
// break打印出来10、9、8、7、6
// continue打印出来10、9、8、7、6、4、3、2、1
for配合range可以用于读取slice和map的数据：
for k,v:=range map {
fmt.Println("map's key:",k)
fmt.Println("map's val:",v)
}
由于 Go 支持 “多值返回”, 而对于“声明而未被调用”的变量, 编译器会报错, 在这种情况下, 可以使用_来丢弃不需要的返回值 例如
for _, v := range map{
fmt.Println("map's val:", v)
}
三.switch语句-其实默认每个case最后面都有一个break
switch sExpr {
case expr1:
some instructions
case expr2:
some other instructions
case expr3:
some other instructions
default:
other code
}
i := 10
switch i {
case 1://这里可以带条件 和if的条件一样
fmt.Println("i is equal to 1")
case 2, 3, 4:
fmt.Println("i is equal to 2, 3 or 4")
case 10:
fmt.Println("i is equal to 10")
default:
fmt.Println("All I know is that i is an integer")
}
integer := 6
switch integer {
case 4:
fmt.Println("The integer was <= 4")
fallthrough/这个一加后面的case语句都会继续判断和执行 相当于取消了break/
case 5:
fmt.Println("The integer was <= 5")
fallthrough
case 6:
fmt.Println("The integer was <= 6")
fallthrough
case 7:
fmt.Println("The integer was <= 7")
fallthrough
case 8:
fmt.Println("The integer was <= 8")
fallthrough
default:
fmt.Println("default case")
}
四.goto break continue
